Underfloor heating thermostat from Under Floor Heating 4u



	Home \| Shop \| Product Approvals \| Support/Instructions \| F.A.Q. \| Terms/Warranty \| News \| Contact Us


	Quick Shop
	160 watt heating mat kits

	200 watt heating mat kits

	Heating cable kits

	5mm in-screed cable kits

	controllers

	insulation board

	accessories


	Shopping Cart
	cart is empty
	Subtotal	£0.00
	Shipping	£0.00
	Tax	£0.00
	Total	£0.00


	View		Checkout




		0800 066 4172

		sales@underfloorheating4u.co.uk

Underfloor heating thermostat



		Electronic Thermostat The Professional Automatic Thermostat: Is fully automatic and programmable (with a 7-day cycle). Comes complete with a floor sensor probe (4m long). Allows control of the room temperature and / or the floor temperature. Allows you to set the maximum floor temperature (as per the manufacturer's recommendations. for different floor finishes) and a minimum floor temperature. Has an IP rating of 21 - allowing it within zone 2 or greater in bathrooms and utility rooms. Is simple to program and operate.


		more details
		The Hot Floors Underfloor Heating Thermostat is able to control up to a maximum of 3600 watts (16 Amps) of heating mats or heating cable. This equates to 24 m2 of 160-watt heating mat, or 360 m of heating cable. If the area you are heating generates more than 3,600 watts then you will either need to have an electrical contactor installed or use an additional thermostat. The Hot Floors thermostat fits flush into a standard UK electrical back box. The electrical back box needs to be a minimum of 47mm deep. This thermostat can be used with all of our heating products and we recommend all our systems be used in conjunction with a thermostat and floor sensor probe.

		2.5m Conduit for floor sensor Hot Floors recommends that when installing our heating systems, the floor sensor be installed in a protective casing of conduit. This simply allows for easy access should the floor sensor fail at some point.


		more details
		The 2.5m conduit is 1cm in diameter and is made of a flexible plastic. A recess must be made in the subfloor to accommodate the conduit so that it will lie flush with the finish floor when covered in levelling compound / tile adhesive / screed depending on the requirements of the system used. This product is only sold in combination with the Hot Floors automatic thermostats and floor sensors. Installation instructions here




Underfloor heating thermostat	© Hot Floors UK Ltd - all rights reserved